Timer Ending / Ended page often loses/corrupts state on Edit

[doubledgedboard]

Not sure if it's due to the number of triggers I have or what, but there appears to be an ongoing bug where when editing triggers they will randomly start losing previous state (or go into a new state which the UI does not properly render).

Re-opening the trigger will cause the state to load correctly some times, but saving it when the state is 'bad' appears to persist that state. See images below.

Action to Reproduce

-- Create a Timer/Trigger that uses a "Timer Ending" alert with Text-To-Speech, and a "Timer Ended" alert with Text-To-Speech
-- Navigate Trigger/Timer Tree in GINA and locate a target Trigger/Timer
-- Double Click the Trigger/Timer

Case 1:
-- Click to view the "Timer Ending" tab

Expected Results:

Audio Settings, "Use Text-To-Speech" has a selected radial button
The previously entered text is visible in the text box and editable

See: https://i.imgur.com/UNwsOBQ.png

Actual Results:

Audio Settings, "No Sound" has a selected radial button
The previously entered text is visible in the text box, but cannot be edited

See: https://i.imgur.com/1xWt0Lx.png

Case 2:
-- Click to view the "Timer Ended" tab

Expected Results:

Audio Settings, "Use Text-To-Speech" has a selected radial button
The previously entered text is visible in the text box and editable

See: https://i.imgur.com/FpuB2hm.png

Actual Results:

Audio Settings, No Visible Radial Button Selected!
The previously entered text is visible in the text box and editable

See: https://i.imgur.com/4giG1ka.png


Side Question, is this project open source? If not, what is the development status? How do you become a contributor? I'd like to contribute rather than just open bug reports.

Thanks in advance!

[doubledgedboard]

Note I also sometimes see the same behavior with the 'Fast Check' checkbox, where it will 're-check' itself.